Ph: 714/842-2603 Fax: 714/847-1824

E-mail: info@coastfab.com

16761 Burke Lane

Huntington Beach, CA 92647

 

Magseal Model 10 Specifications

 
   
 

Please note:  Model 10 is a standard Magseal configuration and is used here for illustrative purposes only. Motorsports designs are typically custom-engineered to meet application requirements.
 

Model 10 - Low Pressure - For use in most applications. Sealing pressure less than 50 PSI depending on size and operating conditions

 

Model 10 Magseals can be manufactured for shafts up to 5 inches in diameter. consult factory for information.

 

Note: Magseals cannot be ordered by size alone. Even in standard configurations material must be matched to the fluids involved. Please contact our Engineering Department at the earliest practical time during your project, and we will design a seal with materials and features suited to your operating conditions.

 

 

 

 

 

 

 

 
       

 

    

Other important parameters:

 

 

 

Standard Model 10

 

Special Design
 

Maximum housing-bore fillet radius

 
Up to size 10-40: .005" 
Size 10-42 and up: .010"

 

Consult Engineering Dept.
 

 

  

 

  

 
 

Maximum axial shaft movement (eccentricity)

 

.010"

 

.030"
 

 

  

 

  

 
 

Maximum forward pressure  ∆P = P1-P2

 

~50 PSID

 

Consult Engineering Dept.
 

 

  

 

  

 
 

Maximum reverse pressure ∆P = P2-P1

 

2 PSID

 

Consult Engineering Dept.
 

 

  

 

  

 
 

Shaft surface finish limitations (O-ring position)

 

Between 32 and 63µ in Ra

 

Between 32 and 63µ in Ra
 

 

  

 

  

 
 
Housing bore or insulator surface finish limitation 
(O-ring position)

 

32µ in Ra (maximum)

 

32µ in Ra (maximum)
 

Magseal is a registered Trade mark of Magnetic Seal Corp.

Technical Inquires: Mike Lang

phone: 714/842-2603  Fax: 714/847-1824  e-mail: mike.lang@coastfab.com