line decor
  
line decor

Home » ITG Air Filters » Megaflow Air Filters

 

JC30-65.

JC30-65

Please Note: Due to rapid fluctuations in the dollar-to-British pound exchange rate, all ITG filter prices are subject to change without notice. Current price is quoted at time of sale. These versatile filters are easily recognizable by their twin bright red bands around the top and bottom; they should not be confused with the many inferior types of foam air filter. The red bands are the visible part of two fiber-reinforced nylon injection moldings which form the structure to which three-layer filter foam is bonded.

The outer two layers give optimum filtration and 'load-up' capacity, while the inner layer is made of a special fire retardant filter foam. Together they give the best combination for airflow, engine protection and safety.

Selection of the filter element depends on the amount of room available. We recommend fitting the tallest filter element you can, with a minimum gap of 1/2 (13mm) over the top of the filter for air to circulate. If rampipes are used there must be a gap between the end of the pipe and the underside of the top of the filter: 3/4 (19mm) is an absolute minimum, and 1 1/4 (32mm) is preferable.

ALL MEGAFLOW FILTERS ARE DEFINED BY THE INTERNAL HEIGHT DIMENSION (A); ALL DIMENSIONS ARE IN MILLIMETERS (MM). PLEASE SEE THE ITG AIR FILTER SECTION ON OUR WEBSITE FOR DIMENSIONAL SPECIFICS.

Most sizes of megaflow filters are also available in domed (sausage) shape: see JC70 illustration of sausage-type filter. The filters listed on the order page comprise the standard range of Megaflow product.

Please note that any filters not in our stock are typically available in 2 weeks or less.

PLEASE CONTACT US WITH ANY QUESTIONS OR IF YOU REQUIRE ADDITIONAL INFORMATION.

Baseplates for Megaflow filters are available as blanks (aluminum) or pre-cuts (red powder coated steel) to fit a variety of carburetors and injectors. Blanks are stock items and application-specific pre-cuts are typically special order from the factory. Contact us for further information.

Dust Retention Fluid (Filter Oil) Filter oil adds significantly to filtration efficiency with a negligible reduction in air flow capacity. ALL ITG FILTER SYSTEMS ARE DESIGNED TO INCORPORATE THE USE OF FILTER OIL: FAILURE TO USE IT GREATLY REDUCES FILTER EFFECTIVENESS. ITG has approved the use of No TOIL oil for all its filters. The oil is applied in 12 oz aerosol cans. No Toil is water-soluble, so filter cleaning requires only warm water and no toil cleaner (Sold in 16 oz bottles). The filter should then be shaken off, air-dried and re-oiled per the instructions provided with the No Toil products.

Email Friend

Price: $93.65
 
« Previous | Next »
     
 
 
 
 
 





   
 
   
About Coast Fabrication

Copyright 2010 - Coast Fabrication, Inc. - All Rights Reserved -
Last updated: December 22, 2010 11:47 AM